Application: Sand or wire brush rusted areas making sure the surface is clean and free of grease, dirt, rust and loose paint. Lightly sand previously painted surfaces to dull the gloss or use a deglosser for maximum adhesion. Hold the can 12 to 14 inches away from the surface and spray in one direction using long even strokes. Repeat this procedure in the opposite direction. On vertical surfaces point the top of the can slightly downward working the wet areas of the spray as you progress down the area to be painted. Continue to apply even coats until a smooth even coat is achieved. On the final coat, move the can closer to the surface approximately 6 to 10 inches for maximum gloss.
Note: After you have achieved a true color, you may find some areas are glossier than others. This is normal and is only overspray. Allow to cure 30 days and lightly buff with a high quality rubbing compound or glass wax to even out the gloss.
VHT ''Epoxy Plus'' Roll Bar & Chassis Coatings contain a one-step Epoxy Ester resin which dries in minutes to provide an exceptional rust and corrosion resistant finish. The rust inhibitors which are added to this product provide a rust proof barrier when applied to new or properly prepared metal substrates. As an added feature, VHT ''EPOXY PLUS'' needs no primer when applied to a clean dry surface. It is truly a one-step coating designed for interior or exterior applications. When applied to ferrous metals, it primes, finishes and prevents rust. VHT ''EPOXY PLUS'' is tough enough for industrial use.
VHT ''EPOXY PLUS'' is formulated to give the appearance and durability of a baked-on finish. It provides a porcelain like finish that is chemical and corrosion resistant and has excellent adhesion.