Saw tooth shaped slots to allow easy adjustment without removing chains or hooks from the lift plate.
Zinc-plated steel plate allows you to lift your engine with the intake manifold installed. Capable of lifting engines with the transmission attached up to 1,000 pounds at three different angles. Has provisions to attach to a small flange Holley 2-bbl, Holley 4150 square flange or spread bore 4-bbl, and Holley 4500 Dominator carb manifolds. Can be used to seal the intake for safe storage as well. Works with all cast iron and aluminum intakes. Make easy work of removing or replacing your 5.0L or 5.8L EFI engine for maintenance or new engine installation. Simply remove the upper intake and bolt our plate to your stock; Edelbrock Performer, Performer RPM, Performer RPM II, Victor; Holley SystemMax; Ford Cobra or GT-40 lower intake manifold. Plate is powdercoated black and has three lift positions to achieve the proper tilt angle. New Design (part number 555-80094) is zinc plated and has saw tooth shaped slots to allow easy adjustment without removing chains or hooks from the lift plate. Most GM LS engines have a plastic intake manifold that should be removed before removing or installing the engine in the vehicle. This lift plate replaces the stock valley cover and has saw teeth style slots that make it easier to balance & angle the engine and transmission while it is being removed or installed. The saw tooth shaped slots allow easy adjustment without removing chains or hooks from the lift plate. The lift plate can also be used as a dust cover to keep the valley clean when storing the engine.Ready for Engine Removal? You Might Need One of These
Universal Engine Lift Plates
Ford EFI Engine Lift Plate
GM LS Engine Lift Plate
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.