- Engines & Components
- Engine - Assembled / Ready-to-Run
- Ford Performance X347D Street Cruiser Crate Engines
Ford Performance Street Cruiser X2347D Ford Small Block Crate Engine 360 Horsepower / 400 Lb.-Ft. Of Torque
397-M6007X2347DR
Rear Sump
Features:
- 360 Horsepower, 400 lb.-ft. of Torque
- 6,000 max RPM
- Bore x Stroke: 4.030 in. bore x 3.400 in. stroke
- Block: Boss 302 8.2 in. deck. (397-M-6010-BOSS302)
- Crankshaft: SCAT Forged Steel
- Connecting Rods: SCAT forged steel, I-beam
- Pistons: Forged Mahle with floating wrist pins
- Cylinder Heads: 64cc chamber Ford Racing aluminum (397-M-6049-X2
- Valve Size: 1.940 in. Intake, 1.540 in. Exhaust
- Compression Ratio: 9.6:1
- Intake: Edelbrock Performer RPM Air Gap Manifold
- Carburetor: Holley Street Avenger 570 CFM with vacuum secondaries, 4-corner idle and electric choke
- Rocker Arms: 1.6:1 roller rockers
- Valve Covers: Ford Racing Aluminum
- Distributor: MSD billet distributor. (121-8598)
- Ford Racing 9MM Black Spark Plug Wires
- Camshaft: Comp Cams hydraulic roller .533 in. lift intake and exhaust, 206 degrees duration intake and exhaust @ .050” lift
- Double roller timing chain set
- Vibration Damper: Ford Racing SFI approved
- Edelbrock standard rotation water pump
- Oil pan: 7-quart capacity and windage tray
- Balanced: internal, use neutral balance flywheel
Engine Break-In Procedure
Use conventional or break-in oil (non-synthetic) for the first 500 miles of operation. Do not drive for long periods at any single speed, always vary your speed. Do not tow a trailer or put other heavy loads on the vehicle. Check the engine oil and coolant levels daily.
At 500 Miles change the engine oil and filter using conventional (non-synthetic) oil. Check fuel and ignition settings; adjust valves (where applicable).
After the first 5,000 of service synthetic engine oil may be used. Follow your vehicle owner’s manual for service intervals.
Specifications:
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.