Small Block Ford
Traditional bearings have three layers: steel, copper-lead, and thin babbitt overlay (only 0.0005" to 0.0008"). JEGS Main Bearings in a Performance or High-Performance series have two layers: high-strength steel and bonded silicon, tin, and copper in an aluminum matrix (0.015" thick). Because an alloy, properties are maintained through its entire depth to deliver consistent, reliable output. Additionally, micro-fine machined High-Performance Bearings have chamfered oil holes and offer a tri-metal copper, lead, and nickel version for some applications. Bearings are sold in sets for Chevy and Ford applications.
High Load Capacity
Aluminum silicon bearings withstand the stress of high-performance engines. JEGS Bearings are made from the same metallurgical alloy so cars that have standard bearings benefit from this alloy used in race engines.
This alloy's melting/fatigue point is 450°+ F (100° more than the thin babbitt overlay of tri-metal bearings). This means extra protection against localized overheating due to misalignment, detonation, overloading, loss of coolant, etc.
More than half of engine bearing failure is caused by metallic particles that scratch crank journals and weaken or tear thin bearing overlays. Because aluminum silicon overlay is much thicker than babbitt in tri-metal bearings (0.015" vs. 0.0008"), it provides 18 times more embedability to trap particles to prevent crank journal scratches. This is especially true for particles over 0.0004", which cause most of the damage.
The thicker aluminum silicon layer allows bearings to better conform to problems, such as metal-to-metal contact due to misalignment. Greater conformability also means fewer bearing failures.
Control of Wall Tolerance
Bearing-to-journal clearance is affected by several factors. We've alleviated concerns about inconsistent shell-to-shell bearing wall thickness by using statistical control methods to minimize wall thickness variation. JEGS Engine Bearing thickness varies no more than 0.00010". Other manufacturers produce bearings with wall thickness at the crown that varies as much as 0.00025".
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.