Throttle Valve Cable Brackets
Note: Does NOT fit Edelbrock Performer-Series carburetors
Throttle Valve (TV) Cables are used in all modern cars with automatic transmissions and they are used to control line pressures, shift points, part throttle downshifts and detent downshifts. The TV cable is attached on one end to the throttle linkage and on the other end, the TV cable is attached to the transmission. As the throttle is depressed, the TV cable is pulled to produce progressively later upshifts at higher throttle positions. Also transmission downshift is produced when the throttle valve cable is pulled a certain amount when the pedal is completely depressed.Features
TCI TV Cable Brackets are designed for correct alignment between the transmission throttle valve cable and the carburetor. A properly adjusted throttle valve cable angle will result in optimal transmission shift performance, and prevent premature transmission wear.
TCI TV Cable Corrector Kits make it easy to install and adjust the TV cable for 700R4 and 2004R transmissions. The easy-to-use design is constructed of steel and comes with all the necessary parts for a clean install. No need to remove the transmission just attach the included brackets to the carburetor, one end of the TV cable to the brackets and the other end of the cable to the transmission.Features:
Will this fit a 750 q jet?
Will this work on an Edelbrock 1406, Performer manifold with stock GM cable?
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.