Includes:
77 Chev K20 383 stroker much fuel pump and fuel tanks. HEI distributor. Looking at Fitech 546/30002K with fuel command . Will this work with my stock distributor?
I have a 1967 mustang and I'm putting a built 302 with mild cam. Will this work for my motor?
Does the fuel command center need to be vented? If so what would be the most painless way to do that? This is the only thing holding me back from buying.
If I only have about 300 hp would this work as well as the 400 hp fi tech? Sbc
I have a 1986 Chevy K10 4x4 350 with mild cam and HEI distributor, currently running a 600cfm Elderbrook carb. Basic engine with only absolute needed sensors- NO KNOCK SENSOR. Other than installing O2 sensor what else would I need to do? Mechanical fuel p
I have a sbc 383 made 507 on the dyno with a quick fuel 750. I have a large cap hei ignition. Would this be a good fit and will my hei work with it ?
Do I need to install a bung in the headers for the O2 sensor?
Hello, I have a 1969 Corvette with a 350, 4spd. Adding Alum 2.02 heads, a GM LT1 Alum intake, COMP CamsXtreme Energy 256H Hydraulic Flat Cam, and already have an EFI Distributor. Car is Street Driver, Want EASY, Reliable: is this Kit the BEST way to go?
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.