Holley 558-499 Transmission Controller Kit for GM 6L80E, 6L90E Transmissions and a Terminator X Max ECU Engine Controller
510-558-499
Product Q&A
View Now
Items You Need
Terminator X Max
Holley 558-499 Transmission Controller Kit Features:
- Handheld tuner with the integrated wizard:
- Plug and play w/engines controlled by a Terminator X Max ECU
- Raise and lower shift points by MPH or RPM
- Read or clear transmission fault codes
- Within the Terminator X V3 PC Software:
- Virtual torque management tables
- Allows use of Tap up/tap down shifting
- TPS (Throttle Position Sensor) tables to dial in shift characteristics on any engine
- DBW (Drive-By-Wire) and Timing torque reduction tables for smooth shifts
Holley 558-499 Transmission Controller Kit Connection Notes:
- Red Power Wire: Connect to constant 12-volt (5 amp) power for the transmission solenoids
- Black Ground Wire: Connect to a good chassis/engine ground source
- Light Blue/White Wire; Connect to the brake light switch wire (12-volt)
- Yellow Wire: Connect to the circuit for the starter solenoid, when the transmission is in park or neutral this wire is grounded, and is open when in gear
Holley 558-499 Transmission Controller Kit Software Notes:
- The Terminator X Max ECU is required for GM 6L80/90E transmission control
- The Terminator X ECU harness is compatible with Terminator X Max ECU if upgrading is needed
- Terminator X V3 Software is not compatible with Terminator X V1 or V2 ECU Firmware
- To use V3 software with an older ECU version, the ECU and handheld MUST be updated to V3 Firmware
- Opening a Terminator X V1 or V2 calibration with Terminator X V3 software, will update the calibration from V1 or V2 to V3
- A V3 calibration cannot be loaded into a V1 or V2 ECU
- A Terminator X V1 or V2 calibration cannot be used in a Terminator X ECU with V3 Firmware
- The 3.5 in. TSLCD can be used to update the ECU & the Calibration from V1 or V2 to V3 when using Handheld Firmware V3 Build xx (tslcd35-terx.3.0.xx.fwu) or later
Emissions Note:
This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.
CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART
Specifications:
Motor Vehicles
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
Tools:
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
Electrical Cords
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.