SSR-III Ready-to-Run (RTR) Pro-Series Distributor Features:
- Magnetic Trigger
- Forged Aluminum Housing
- Distributor Cap with Solid Brass Male Terminals
- Ready to Run... No Additional Ignition Box Required
- Centerless Ground 0.500 in. Diameter Shaft with Upper Sealed Roller Bearing
- 35% Higher Output Voltage
Professional Series Ready-To-Run Distributors
JEGS SSR-III Pro Series RTR Distributors come ready-to-run out of the box! Featuring a magnetic trigger, built-in module and does not require a separate ignition box to operate. All-Pro Series distributors come with a CNC-machined, forged aluminum housing; while the polished 1/2 in. shaft is centerless ground allowing for tighter tolerances and a smoother finish after manufacturing. The shaft rides in an upper-sealed roller bearing and lower oil-impregnated bronze bushing, for reduced friction and premature wear. Equipped with a small-diameter male cap with brass terminals, these reliable distributors come complete with wiring and connector harnesses. Expect years of accurate operation with a 35 percent increase in voltage output overstock, and performance up to 10,000 RPM from every Pro-Series RTR Distributor.
What coil is recommended for this unit
Will this work on carb'd engines? Carb'd 5.0 explorer
WARNING: Motor vehicles contain fuel, oils and fluids, battery posts, terminals and related accessories which contain lead and lead compounds and other chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. These chemicals are found in vehicles, vehicle parts and accessories, both new and as replacements. When being serviced, these vehicles generate used oil, waste fluids, grease, fumes and particulates, all known to the State of California to cause cancer, birth defects, and reproductive harm.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically treated lumber. Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
WARNING: The wires of these products contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.